- Home
- Accessories
- Cell Phones & Accessories
- Signal Booster Accessories
- Band-5 Cellular Signal Filter (Channel B, F-Female Connector)
Wilson Electronics
Band-5 Cellular Signal Filter (Channel B, F-Female Connector)
- SKU:
- WB860002
- UPC:
- 811815026181
- MPN:
- 860002
- Shipping:
- Calculated at Checkout
MSRP:
Now:
$102.95
Was:
— You save
Description
Filters out the undesired signal on Channel-B, Band-5; Channel-B downlink: 880MHz-894MHz; Channel-B uplink: 840MHz-849MHz; Connects between outside cellular antenna & Wilson(R) 50ohm amps ; F-female input & output ; For use with 50ohm jumper cable (not included); Easy to install with included mounting tabs
Warranty: Two Years
Country of Origin: United States
View AllClose
Warranty: Two Years
Country of Origin: United States
Related Products

Wilson Cellular Signal Splitter 4 Way -6 dB w/N Female Connectors, 50 Ohm
Wilson Electronics
MSRP:
Now:
$119.99
Was:
The Wilson four-way -6 dB Splitter allows you to split the amplified signal with equal signal loss to four inside antennas in similarly sized areas. Covers all cellular frequencies 700MHz to 2700MHz...

Wilson 20 dB Cellular Signal Attenuator, 50 Ohm (N Female Connectors)
Wilson Electronics
MSRP:
Now:
$40.95
Was:
This 20dB RF Attenuator reduces the level of all cellular signals either to the input of a 50-Ohm cellular booster or from the output of the cellular booster. Attenuator is 50-Ohm and features...

WilsonPro Band 5 Channel A Filter (F Connector)
Wilson Electronics
MSRP:
Now:
$102.95
Was:
Designed to provide maximum attenuation for Channel A, Band 5, and allow other channels to pass through with minimal attenuation.Channel A includes: Downlink: 869-875 MHz/ Uplink: 824-830 MHz.The...

WilsonPro Band 5 Channel A Filter (N Connector)
Wilson Electronics
MSRP:
Now:
$102.95
Was:
Designed to provide maximum attenuation for Channel A, Band 5, and allow other channels to pass through with minimal attenuation. Channel A includes: Downlink: 869-875 MHz/ Uplink: 824-830 MHz.This...

WilsonPro Band 5 Channel B Filter (N Connector) | 860004
Wilson Electronics
MSRP:
Now:
$102.95
Was:
Filters out the undesired signal on Band 5Connects the outside antenna and amplifiersEasy to install
Customers Also Viewed

Marine Antenna Kit with Mount & SMA-Male Cable, 20ft
Wilson Electronics
MSRP:
Now:
$118.95
Was:
Weatherproof & waterproof fiberglass casing; Antenna reaches 21" high; Dual-band 800MHz/1,900MHz; Works on all US cellular frequencies; Built-in ground plane; Antenna's signal gain: 5.12db; Includes...

Antennas Direct PA18 Antenna Kit
Antennas Direct
MSRP:
Now:
$54.95
Was:
The PA-18 is an ultra low noise, mast mounted pre-amp system that provides a gain of 15 db and a 1.8 dB maximum noise figure. The PA-18 offers overload resistance, a scatter filter and superior RF...

Holland CISP-HR Cable Isolation Filter with Spike Protection
Holland Electronics
MSRP:
$14.99
Now:
$10.99
Was:
The Holland Electronics CISP-HR cable isolator has been developed to prevent shock or fire damage to the subscriber's premises or cable system due to power line voltages entering the cable on...

HPF-54-HR Holland Electronics High Pass Filter to Block Sub Band Signals
Holland Electronics
MSRP:
$14.99
Now:
$2.89
Was:
The Holland Electronics HPF-54-HR high pass filter attenuates ingress noise in the sub-band section of the cable spectrum to optimize return path services. This filter can also beused to...


Pico Tru Spec HPFO-54MHz Digital Cable TV High Pass Filter
Pico Digital
MSRP:
$12.99
Now:
$2.95
Was:
The Tru Spec by Pico Digital HPFO-54MHz Cable TV High Pass Filter is designed to block interference from Cable Modems and sub-band return signals from other CATV set top boxes...

Holland MPOE-TM MoCA POE Filter for Cable TV Coaxial Networking
Holland Electronics
MSRP:
$19.99
Now:
$4.29
Was:
Holland Electronics MPOE-TM MoCA P.O.E. Point of Entry Filter for Cable TV
The Holland POE filter Model MPOE-TM was developed specifically for use on Cable TV subscriber premise internal coaxial...