Atlona Two-Input Wall Plate Switcher for HDMI and VGA Sources with HDBaseT Output

Calculated at Checkout


The Atlona AT-HDVS-150-TX-WP is a 2�1 wall plate switcher with display control for HDMI and VGA transmission over HDBaseT™. It features an HDMI input plus VGA input with 3.5mm audio connector on a two-gang, US or UK wall plate. Plates without buttons are also available (AT-HDVS-TX-WP-NB). Designed as a remote input device for the AT-UHD-CLSO-824 matrix switcher, the AT-HDVS-150-TX-WP combines the benefits of a switcher with built-in auto-switching and the advantages of long-distance HDBaseT signal extension over a single cable. Video signals up to 1080p/60Hz with embedded audio, VGA input signals up to 1920�1200 video, and control signals can be extended up to 230 feet (70 meters). The switcher enables auto display on/off, auto-switching, along with other features. The switcher is receives power from the AT-UHD-CLSO-824 using Power over Ethernet. The AT-HDVS-150-TX fits inside any 40 mm deep two-gang electrical box or mud ring and is ideal for long distance transmission and display control in corporate or educational settings using analog and digital sources.

The Atlona AT-HDVS-150-TX-WP switcher expands the input capabilities of the AT-UHD-CLSO-824. Each remote switcher provides input access for up to two devices with controls for input selection and can control display power state when used with a third party control system. The HDVS series is designed to smooth the transition from analog to digital displays, allowing advanced HDMI display devices to be used with legacy VGA sources. The series also adds the simplicity and performance of HDBaseT technology to eliminate multiple cable runs and signal degradation that can occur with long transmission lines. Cost-effective and easy-to-terminate category cable provides additional integration benefits.
  • US, 2-gang wall plate, Shallow, 1.5 in (40 mm) deep wall plate simplifies integration with recessed RJ-45 connector, Attractive alternative to table-top boxes for placement near presenter's station, Optional UK version available: AT-HDVS-150-TX-WP-UK
  • 2�1 HDBaseT™ switcher, Features an HDMI input plus VGA input with 3.5mm audio connector, Allows advanced HDMI display devices to be used with legacy VGA sources
  • Long distance HDMI extension, Transmits AV signals up to 230 ft (70m) @ 1080P and 130 ft. (40m) @ 4K/UHD using CAT6a/7 cable, Uses easy-to-integrate category cable for low-cost, reliable system installation
  • Automatic display control, Automatically changes projector power state based on active or standby mode of the switcher (in conjunction with the AT-HDVS-150-RX). Control signals are transmitted via RS-232., Eliminates the need for a complex control system in small AV systems
  • Automatic input selection using 5 volt detection, Selects active input when sources are connected or if there is a change in source power status, Eliminates need for complex control system in small AV systems
  • Front panel display on/off control, Remotely controls display power state; provides alternate 'Display Mute' mode, Eliminates need for manual operation of display or use of IR remote control
  • Front panel input select button, Overrides auto-switching when two active sources are present, Simple manual control allows presenter to maintain control of AV system
  • Optional "No Button" US faceplate, AT-HDVS-TX-WP-NB Accessory Blank Face Plate, Allows input control only from 3rd party switcher, Allows the presenter to control the meeting
View AllClose